SUBARU IMPREZA WRX STI V SPEC FRONT LIP MY03 - MY05

Customise the look of your IMPREZA, WRX or STI with this V SPEC style front lip.  This is a great aftermarket V SPEC style polyurethane front lip for WRX and STI MY03 to MY05 sedan.

Being polyurethane, it will last as more flexible and durable than many other materials. Can be installed without the front splitters but if installed without splitters, will have some gaps on the Impreza that are visible (do consider our alternative PU or carbon lips if you do not plan to install splitters as they look and fit better when installed without splitters).

Lip is supplied in flat black.

Fits Sedan - but can be fitted to the hatch but mods required for hatch (heat and soften lip and remold to the narrower front bar shape - plus additional screws required)

A great looking aftermarket front lip for your Subaru Impreza, WRX or STI!

IMPORTANT INFORMATION TO CONSIDER BEFORE PURCHASING - PLEASE READ CAREFULLY

Due to the polyurethane construction of this part, it may occasionally warp during transit. Upon arrival, the part may require heat treatment and remolding to restore it to its original factory shape.

While the product is molded to a specific fit, some level of reshaping is occasionally necessary to prepare it for installation. Please note that warping or distortion is considered normal for this product and is not a basis for a warranty claim, return, exchange, or refund (full or partial).

We have sold thousands of polyurethane parts over the past 15 years; however, warping during transit is a factor beyond our control. If you are not prepared to spend the time necessary to heat and reshape this part if required, we recommend that you do not proceed with the purchase.

Installation Guide for Polyurethane Parts

Polyurethane is an ideal material for aftermarket body components due to its flexibility; however, these parts can occasionally warp during transit. If your part has arrived with any warping, please be assured that it can be easily corrected.

To restore the original molded shape, please use one of the following methods:

- Heat Gun: Apply heat to the affected area to soften the material, then apply pressure until it returns to its intended shape.

- Sunlight: On a hot day, place the part in direct sunlight for several hours until it softens, then apply pressure to reshape it.

For the best results, we recommend installing the part while it is still warm and pliable. This can be achieved by laying the part flat in direct sunlight for a few hours prior to installation or by using a heat gun.