SUBARU IMPREZA STI STYLE FRONT LIP MY03 - MY05 POLYURETHANE

This ULTREX PERFORMANCE STI Style front lip looks HOT!

Made from polyurethane so it will last and last, it fits all WRX and STI MY03-05's sedans.

Can be installed without the front splitters but if installed without splitters, will have some gaps that are visible (do consider our alternative PU front lip or carbon lips if you do not plan to install splitters as they look and fit better when installed without splitters). We also have stock of the front splitters if you want these.

Lip is supplied in flat black and is ready to just bolt on/screw on.

A great looking aftermarket mod for your WRX or STI!

Fits Subaru Impreza WRX and STI MY03 MY04 MY05 with or without front splitters however when installed without splitters there will some gaps visable in a couple of spots between the lip and the front bar. If you do not want to install splitters, consider our alternative PU or CF or fibreglass lips which look better when no splitters are installed (no gaps visible).

IMPORTANT INFORMATION TO CONSIDER BEFORE PURCHASING - PLEASE READ CAREFULLY

Due to the polyurethane construction of this part, it may occasionally warp during transit. Upon arrival, the part may require heat treatment and remolding to restore it to its original factory shape.

While the product is molded to a specific fit, some level of reshaping is occasionally necessary to prepare it for installation. Please note that warping or distortion is considered normal for this product and is not a basis for a warranty claim, return, exchange, or refund (full or partial).

We have sold thousands of polyurethane parts over the past 15 years; however, warping during transit is a factor beyond our control. If you are not prepared to spend the time necessary to heat and reshape this part if required, we recommend that you do not proceed with the purchase.

Installation Guide for Polyurethane Parts

Polyurethane is an ideal material for aftermarket body components due to its flexibility; however, these parts can occasionally warp during transit. If your part has arrived with any warping, please be assured that it can be easily corrected.

To restore the original molded shape, please use one of the following methods:

- Heat Gun: Apply heat to the affected area to soften the material, then apply pressure until it returns to its intended shape.

- Sunlight: On a hot day, place the part in direct sunlight for several hours until it softens, then apply pressure to reshape it.

For the best results, we recommend installing the part while it is still warm and pliable. This can be achieved by laying the part flat in direct sunlight for a few hours prior to installation or by using a heat gun.