SUBARU IMPREZA & WRX MY03-05 FRONT LIP, SPLITTERS & FOG COVERS

This is everything needed to transform the front end of your WRX or Impreza to look like an STI.
It includes:
1 x STI front lip polyurethane
2 x STI side splitters polyurethane
2 x STI fog light covers

These parts are a direct bolt on to the WRX sedan MY03-05 & Impreza sedan my03-05. It can also be fitted to the WRX Hatch / Impreza hatch with minor mods.

Parts are unpainted and require prep, painting and fitting. Professional installation recommended to get the best result.

We can sell the STI side skirts, rear pods and rear spoiler. Message us for prices.

Fits Impreza & WRX MY03-05 Sedan only - and hatch with minor mods.

IMPORTANT INFORMATION TO CONSIDER BEFORE PURCHASING - PLEASE READ CAREFULLY

Due to the polyurethane construction of this part, it may occasionally warp during transit. Upon arrival, the part may require heat treatment and remolding to restore it to its original factory shape.

While the product is molded to a specific fit, some level of reshaping is occasionally necessary to prepare it for installation. Please note that warping or distortion is considered normal for this product and is not a basis for a warranty claim, return, exchange, or refund (full or partial).

We have sold thousands of polyurethane parts over the past 15 years; however, warping during transit is a factor beyond our control. If you are not prepared to spend the time necessary to heat and reshape this part if required, we recommend that you do not proceed with the purchase.

Installation Guide for Polyurethane Parts

Polyurethane is an ideal material for aftermarket body components due to its flexibility; however, these parts can occasionally warp during transit. If your part has arrived with any warping, please be assured that it can be easily corrected.

To restore the original molded shape, please use one of the following methods:

- Heat Gun: Apply heat to the affected area to soften the material, then apply pressure until it returns to its intended shape.

- Sunlight: On a hot day, place the part in direct sunlight for several hours until it softens, then apply pressure to reshape it.

For the best results, we recommend installing the part while it is still warm and pliable. This can be achieved by laying the part flat in direct sunlight for a few hours prior to installation or by using a heat gun.