ULTREX PERFORMANCE FRONT LIP SPOILER FITS SUBARU FORESTER MY09 - MY12

We love this Subaru Forester front lip as it really transforms the look and front end of the SH Forester.

Made from polyurethane, its flexible and installed using the supplied fitting kit of self tapping screws.

This is by far the biggest and most difficult to install front lip that we sell. This lip is supplied RAW in flat black and requires requires preperation / primer / paint / install by a skilled professional to get the best results. It is a harder lip to install so many newby DIY installers wont be able to get a great result - professional install strongly recommended.

Fits SUBARU FORESTER SH MY09 - MY12 only

IMPORTANT INFORMATION TO CONSIDER BEFORE PURCHASING - IF YOU DO NOT AGREE - DO NOT PURCHASE!

Due to this front lip's large size and polyurethane construction, it can warp in transit. Upon arrival, it may require heat treatment and remolding to restore it to its original factory shape. While it is molded to a specific fit, you will need to apply heat to restore the correct shape if warping has occurred.

Please note that warping or distortion is considered normal for this product and is not a basis for a warranty claim, return, or refund (full or partial). Generally, the lip will require some level of heat and remolding to optimize it for installation.

We have sold this product for over 10 years to hundreds of satisfied customers; however, it is the largest lip we sell and the most difficult to fit. This part will often arrive with some level of distortion, so if you are not prepared to spend the time necessary to heat and reshape it, we recommend that you do not proceed with the purchase.

If you would like futher clarity or information on the above, please call us on 1300 343 500 9-4pm business days Perth time.

Installation Guide for Polyurethane Parts

Polyurethane is an ideal material for aftermarket body components due to its flexibility; however, these parts can occasionally warp during transit. If your part has arrived with any warping, please be assured that it can be easily corrected.

To restore the original molded shape, please use one of the following methods:

- Heat Gun: Apply heat to the affected area to soften the material, then apply pressure until it returns to its intended shape.

- Sunlight: On a hot day, place the part in direct sunlight for several hours until it softens, then apply pressure to reshape it.

For the best results, we recommend installing the part while it is still warm and pliable. This can be achieved by laying the part flat in direct sunlight for a few hours prior to installation or by using a heat gun.