SUBARU IMPREZA WRX & RS FRONT LIP FOR MY08-10 CS STYLE

Customise the look of your Subaru WRX or RS with this hot looking CS style front lip. Fits Subaru Impreza WRX and RS MY08 MY09 MY10.

This listing consists of:

1 x front lip plus fitting kit to install.

All made from high quality polyurethane which is very flexible and perfect for body kits as more forgiving than ABS or carbon or fibreglass. This kit is supplied in flat black - if you are super fussy you may want to spray it but the kit on the car is as supplied in flat black and looks great!

Everything you need to install is included and it's a simple DIY job.

Fits Subaru WRX / RS Sedan and Hatch  - MY08 - MY09 - MY10 only.

IMPORTANT INFORMATION TO CONSIDER BEFORE PURCHASING - PLEASE READ CAREFULLY

Due to the polyurethane construction of this part, it may occasionally warp during transit. Upon arrival, the part may require heat treatment and remolding to restore it to its original factory shape.

While the product is molded to a specific fit, some level of reshaping is occasionally necessary to prepare it for installation. Please note that warping or distortion is considered normal for this product and is not a basis for a warranty claim, return, exchange, or refund (full or partial).

We have sold thousands of polyurethane parts over the past 15 years; however, warping during transit is a factor beyond our control. If you are not prepared to spend the time necessary to heat and reshape this part if required, we recommend that you do not proceed with the purchase.

Installation Guide for Polyurethane Parts

Polyurethane is an ideal material for aftermarket body components due to its flexibility; however, these parts can occasionally warp during transit. If your part has arrived with any warping, please be assured that it can be easily corrected.

To restore the original molded shape, please use one of the following methods:

- Heat Gun: Apply heat to the affected area to soften the material, then apply pressure until it returns to its intended shape.

- Sunlight: On a hot day, place the part in direct sunlight for several hours until it softens, then apply pressure to reshape it.

For the best results, we recommend installing the part while it is still warm and pliable. This can be achieved by laying the part flat in direct sunlight for a few hours prior to installation or by using a heat gun.